I started playing around with Nuvo interfacing. I went down the list of about 36 commands in Command Builder. Most commands seems to work well for me (Nuvo GC, 14 zones). I can turn on and off various keypads, adjust volume and source. Pretty cool.
However some of the commands don't seem to work. I've listed them below. I'd be happy to give details, I kept this short.
ZoneMessage. Sort of works. However optional message type does not do anything, such as Flash, Error, or Warning. Messages never stay on longer than about 2 seconds.
SourceMessage. Same as ZoneMessage above, but for Sources.
SetSourceName. Does not do anything. Edited Command Builder syntax but still did not work.
GroupMessage. Does not do anything.
Display. Does not do anything.
1) Is this unique to me, Command Builder syntax errors, or do these commands just not work?
2) Is this list of about 36 commands in Command Builder the entire command list?
I'm trying to work up a synced up keypad display for the meta data and transport control. Any help or shared code is appreciated.
Live long and prosper.