myServer 6 supports the GlobalCache line of control products.
Most common would be the "IP2IR" device that allows myServer 6 to send IR commands out the hardware's three IR emitter ports.

This driver supports over 200,000 IR devices!

The driver also support the iTach Flex hardware.  This hardware is configurable to read contact closures, voltage levels, or to trigger relays.

 

If you are controlling multiple cable boxes in your system (like for a sports bar):

For each of the cable boxes, document an ip address of the IP2IR and port. Ideally, these would be in sequential order where the lowest ip address – port 1 is for cable box 1, etc. So if the ip address for the first IP2IR is 192.168.10.10 (for example) then it would be:

 

Cable 1: 192.168.10.10 – port 1

Cable 2: 192.168.10.10 – port 2

Cable 3: 192.168.10.10 – port 3

Cable 4: 192.168.10.11 – port 1

Cable 5: 192.168.10.11 – port 2

Cable 6: 192.168.10.11 – port 3