myServer 6 supports the Phillips Hue brand of connected lights.

The myServer controller communicates to the Hue Bridge, which then communicates to the individual Hue lights.

Dependent on the bulb, On / Off / Dim and colors are supported.

Installation

• Ensure that myServer is on the same network subnet as the Bridge to ensure it's found.
• Install the Phillips Hue driver from myServer Software Updater.
• Click the Setup button on the Hue Bridge.
• Run the Discover command in the myServer Hue Driver Command Builder.

In a few minutes, your Hue Bridge should be auto discovered.  You can then try commands in the Command Builder.

 

 Device type should be "Lighting".