How goes Harmony Hub implementations?

Thank you for your input. I was getting tired and grumpy last night because it was one of those days where nothing had gone as planned (and not just with the remote!). While poking around in the hard button menus in myDesigner I did find some code that seems to handle looping commands if you hold a button but I'm not yet sure of how to modify the syntax in order to use them with other devices. I'll eventually figure it out. I knew this was going to be a project and I'm not expecting Rome to be built in a day. It's all good.

I have the day off today so I'm going to work on it a bit more. I suspect I'll be starting a couple threads today trying to address a few concerns I have. Thanks again!

 

There will be an update to the Harmony driver today along with updated documentation and YouTube video.
This will fix this issues reported so far.
 

What is the expected timeline for updated documentation and YouTube video?
I purchased 2 hours of support. Can I use some of it to set up Harmony?

We are still testing a significant update to Harmony Hub integration.
Hold tight.
Sure you could use the hours for that...but lets see when we are done here.

Thanks. I guess I will sit tight. ETA?

Harmony driver update is done but documentation is not done. Got sidetracked by an urgent driver request. Harmony will be the next driver released.

One big harmony change is that Harmony activities and devices will now show up on the home page on the remote.