UPB Getting Started

Having a hard time finding UPB documentation.   If it exists and someone could direct me to it, would be appreciated.   If not, I have a couple quick questions.

1) How or where do I load the UPB UPE file with all the devices?
2) Will it work with a USB PIM?   I only see network and serial PIM.   Although I think maybe the USB PIM emulates a serial PIM.

Thx

Once you add the UPB driver from myServer Software Updater, click on HOW TO from the driver's configuration window. This will open the current documentation. There is basic installation instructions there that is DRAFT. We have a few commercial installations that use UPB but not too many DIY users as the technology has been around a long time and been replaced with "Z-Wave" and "ZigBee" in popularity. But it should work fine once configured.

Thanks David. I'll check that out when I get back home. Out west for a couple weeks right now. I tried the "How To" button a couple times when I was home and as I recall there was a landing page for UPB but nothing there.

Edit:  I see my mistake.   i finally found it under "Connectivity."    I was looking under "Lighting."   I'll give it a spin when I get home.